Measure the length of your table. We will make this top to your dimensions +/- 1/8 of an inch.

You can measure right up to the edge of the table to protect the wood, but can not have any overhang. Overhanging edges tend to get hit and could make the top slide a bit.

Please make you measurements in inches and fractions (for instance 48 3/4 inches)

Measure the width of your table, again with no overhang.

Most pool tables have corners that look similer to this. This is our standard corner, and no pattern is needed. Enter "standard corners" on the order form.

This is an example of a corner that might need a pattern. The standard radius would work if you undersize the top a bit. In this example, if you measure the overall dimensions to the outside of the pockets instead of the outside of the rails the standard corner will work.

If you think you need a pattern enter "need pattern" on the order form and I will contact you with instructions. It's really very easy!